Routing
108
7.2
Configuring Router Interfaces
RM Web L3P
Release
4.1
03/08
Configuring the port-based router interface
Double-click on a cell in the "IP Address" column and enter the
IP address for this router interface.
Double-click on a cell in the "Network mask" column and enter the
network mask for this router interface.
Click once on a cell in the "Routing" column to switch on the routing
function for this router interface.
Click once on a cell in the "Proxy ARP" column to switch on the proxy
ARP function for this router interface.
Setting up a VLAN-based router interface
Click on the "Wizard" on the bottom right.
In the Wizard window,
– select a row in the table to configure an existing VLAN, or
– enter a VLAN ID for a new VLAN to be configured.
Click on "Continue".
In the next Wizard window, enter the name of your choice under
"VLAN Name".
In the "Member" column select the ports you wish to assign to the
VLAN.
"Untagged": In this column you select the ports that you want to be
members of the VLAN and that will send data packets without a tag.
"Port VLAN ID": Double-click on a cell in this column in order to change
the port VLAN ID. A tag with this port VLAN ID is added to data packets
which this port receives without a tag.
Click on "Continue".
In the "Primary IP Address" frame you enter the IP address of this
router interface and the related network mask.
The "Secondary Addresses/Multinetting" frame enables you to assign
additional IP addresses to this router interface. Enter the IP address
and the network mask.
Click on "Add" to transfer the entries into the table.
Select a row in the table to delete it from the table using "Remove".
Click on "Finish" to transfer the configured VLAN-based router inter-
face into the router interface table.
To Next Page
Loading...
Need help?
General
