Hirschmann Power MICE - Signal Contact; Manual Setting; Function Monitoring

Diagnostics
RM Web L3P
Release 4.1 03/08
9.6 Signal contact
195
9.6 Signal contact
The signal contacts are used for
X controlling external devices by manually setting the signal contacts,
X monitoring the functions of the device,
X reporting the device state of the device.
9.6.1 Manual setting
 Select the tab page "Alarm 1" or "Alarm 2" (for devices with two signal
contacts).
 In the "Signal contact mode" field, you select the "Manual setting" mode.
With this mode you can control this signal contact remotely.
 Select "Opened" in the "Manual setting" frame to open the contact.
 Select "Closed" in the "Manual setting" frame to close the contact.
Application options:
X Simulation of an error during SPS error monitoring.
X
Remote control of a device via SNMP, such as switching on a camera.
9.6.2 Function monitoring
 Select the tab page “Alarm 1” or “Alarm 2” (for devices with two signal
contacts).