Advanced
208
10.2
DHCP Server
RM Web L3P
Release
4.1
03/08
10.2DHCP Server
With this dialog you can very easily include new devices (clients) in your
network or exchange them in your network: When you select DHCP as the
configuration mode for the client, the client gets the configuration data from
the DHCP server.
The DHCP server assigns the following to the client:
– a fixed IP address set (static) or an address from an address range
(dynamic)
– the network mask
– the gateway address
– the DNS server address
– the WINS server address and
– the lease time.
You can also specify an URL per port for transferring additional configuration
parameters to the client.
Parameter Meaning
Active Switching the DHCP server on and off.
Table 45: Switching DHCP on and off globally
Parameter Meaning
First IP address Enter the first IP address of the IP address range from which the DHCP
server can assign IP addresses to the client
Last IP address Enter the last IP address of the IP address range from which the DHCP
server can assign IP addresses to the client
Table 46: DHCP - Dynamic Address Range
To Next Page
Loading...
Need help?
General
