Basic Settings
22
2.2
Network
RM Web L3P
Release
4.1
03/08
2.2 Network
With the Basics:Network dialog you define the source from which the
device gets its IP parameters after starting, and you assign the IP parameters
and VLAN ID and configure the HiDiscovery access.
Figure 9: Network parameters dialog
Under "Mode", enter where the device is to obtain its IP parameters:
X In the BOOTP mode, the configuration is via a BOOTP or DHCP serv-
er on the basis of the MAC address of the device (see page 32 „Saving
the configuration“).
X In the DHCP mode, the configuration is via a DHCP server on the ba-
sis of the MAC address or the name of the device (see page 32 „Sav-
ing the configuration“).
X In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
To Next Page
Loading...
Need help?
General
