Basic Settings
32
2.6
Load/Save
RM Web L3P
Release
4.1
03/08
2.6.1 Loading the configuration
In the "Load" frame, you have the option to
X load a configuration saved on the device,
X load a configuration stored under the specified URL,
X load a configuration stored on the specified URL and save it on the
device,
X load a configuration stored on the PC as an editable and readable script
or in binary form.
If you change the current configuration (for example, by switching a port off),
the load/save symbol in the menu area changes from a disk symbol into a
yellow triangle. After saving the configuration, the load/save symbol changes
back into the disk symbol.
2.6.2 Saving the configuration
In the "Save" frame, you have the option to
X save the current configuration on the device,
X save the current configuration in binary form in a file under the specified
URL, or as an editable and readable script,
X save the current configuration in binary form or as an editable and read-
able script on the PC.
Note: The loading process started by DHCP/BOOTP (see on page 22 „Net-
work“) shows the selection of "from URL & save local" in the "Load" frame. If
you get an error message when saving a configuration, this could be due to
an active loading process. DHCP/BOOTP only finishes a loading process
when a valid configuration has been loaded. If DHCP/BOOTP does not find
a valid configuration, then finish the loading process by loading the local con-
figuration in the "Load" frame.