Basic Settings
RM Web L3P
Release
4.1
03/08
2.4
Port Configuration
27
Note: If you have set up VLANs, pay attention to the “Transparent mode”
under „Setting up the VLAN“ on page 84“.
Note: The active automatic configuration has priority over the manual
configuration.
Note: For configuring link aggregation, see „Link aggregation“ on page 128“.
Note: . The following settings are required for the ring ports in a HIPER-Ring:
When you switch the DIP switch for the ring ports, the device sets the
required settings for the ring ports in the configuration table. The port, which
has been switched from a ring port to a normal port, is given the settings
Autonegotiation (automatic configuration) on and Port on. The settings
remain changeable for all ports.
Bit rate 100 Mbit/s 1000 Mbit/s
Autonegotiation
(automatic configuration)
Off On
Port On On
Duplex Full –
Table 2: Port settings for ring ports
To Next Page
Loading...
