Basic Settings
30
2.5
Power over ETHERNET
RM Web L3P
Release
4.1
03/08
The difference between the "nominal" and "reserved" power indicates how
much power is still available to the free PoE ports.
In the “Port on” column, you can enable/disable PoE at this port.
The “Status” column indicates the PoE status of the port.
In the “Priority” column (MACH 4000), set the PoE priority of the port to
“low”, “high” or “critical”.
The “Class” column shows the class of the connected device:
Class Maximum power delivered
0 15.4 W = state on delivery
1 4.0 W
2 7.0 W
3 15.4 W
4 Reserved, treat as class 0
The “Name” column indicates the name of the port, see
Basic settings:Port configuration.
Figure 12: Power over Ethernet dialog
To Next Page
Loading...
