Black plate (19,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Driving and Operating 9-19
.
When reverse gear is selected
and the rear and front sensors
both detect objects, only the
closest object will be indicated.
.
If two objects at the same
distance are detected, the object
at the rear of the vehicle will be
given p riority.
.
When reverse is selected, the
animation is displayed on the
infotainment screen.
.
If the sensors are activated, an
animation will display the
detection range.
.
If an object enters the range, the
sector will illuminate green. As
the distance decreases,
additional sectors will ill uminate
and the colour will change to
yellow, orange and finally red.
.
When drive is selected, the
animation is shown only when
the sensors detect an object and
the vehicle’s speed is below
15 km/h.
.
If a short tone is heard when
there are no objects visible, it
may be due to ground
reflections, children or animals.
Be aware.
.
Keep bumper sensors free from
dirt, scratches, grime, ice, frost
and snow with a soft cloth.
Operation
The DPA is activated automatically
when the following occur:
.
The ignition is switched on.
.
A gear is selected.
.
The parking brake is released.
Once reverse gear is selected, a
single short tone sounds from the
rear speaker to confirm that both the
rear and front sensors are
operational.
When a forward gear is selected
after reversing, the front and rear
sensors will remain operational until
the vehicle’s speed exceeds
15 km/h.
If a forward gear is selected, only
the front sensors are activated and
the tone will sound from the front
speaker.
Note: The DPA:
.
Automatically deactivates when
the vehicle’s speed exceeds
15 km/h.
.
Is reactivated if changing from a
forward to reverse gear or vice
versa, or if the ignition is
switched off and then on again.
.
When manually deactivated, will
not au tomatically activate until
the DPA has been manually
reactivated.
To Next Page
Loading...
Need help?
General
