HOLDEN WM II 2012 Series - Page 301

Black plate (55,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
/
12
Vehicle Care 10-55
C
21. With the other hand, turn the
handle through 180 degrees
until it reaches position (C).
D
22. Rotate the handle clockwise
from position (C) to
position (D).
23. Repeat Steps 20 to 22 until the
bottom of the flat tyre is about
5 cm above the ground.
24. Go to Step 30.
Wheel wrench jack handle
25. Unfold the wheel wrench so it
forms a right angle.
26. Slide the wheel wrench onto
the drive nut of the jack.
E
27. Turn the wheel wrench through
180 degrees until it reaches
position (E).
F
28. Rotate the wheel wrench
clockwise from position (E) to
position (F).
29. Repeat Steps 27 to 28 until the
bottom of the flat tyre is about
5 cm above the ground.
30. Remove the wheel nuts and
place in a clean, dry place.
31. Exchange the wheel on the
vehicle with the spare wheel.