Black plate (59,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Vehicle Care 10-59
17. Position the jack beneath the
jack location closest to the
wheel being changed.
The locations are identified by
cutouts in the underside of the
door sill.
18. Wind the jack up by hand until
it engages with the jacking
point.
Ensure that the jack is not tilted
and the base is resting
squarely on the ground.
{
WARNING
Failure to position the jack as
described could cause the vehicle
to slip off the jack.
Do not get under a v ehicle that is
supported by a jack. No person
should place any portion of their
body under a vehicle that is
supported by a jack.
19. Unfold the wheel wrench so it
forms a right angle.
20. Slide the wheel wrench onto
the drive nut of the jack.
K
21. Turn the wheel wrench through
180 degrees until it reaches
position (K).
To Next Page
Loading...
