Black plate (60,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
10-60 Vehicle Care
L
22. Rotate the wheel wrench
clockwise from position (K) to
position (L).
23. Repeat Steps 21 to 22 until the
bottom of the flat tyre is about
5 cm above the ground.
24. Remove the wheel nuts and
place in a clean, dry place.
25. Exchange the wheel on the
vehicle with the spare wheel.
26. Replace the wheel nuts and
lightly tighten with the wheel
nut wrench.
27. Lower the vehicle by reversing
the jacking procedure.
28. Remove the jack from under
the vehicle.
29. With the wheel on the ground,
use the unfolded wheel wrench
to tighten the wheel nuts in the
sequence shown.
{
WARNING
To tighten the wheel nuts, the
wrench must be fully unfolded.
30. Replace wheel trims or
nut caps.
31. Replace the tools on the
tyre tray.
32. Replace the jack package
cover.
33. Tighten the jack package nut
firmly by hand.
34. Place the wheel on the
tyre tray.
35. Replace the carpet cover.
36. Slide the wheel and tyre tray
pack into its original position.
37. Fasten the retainer by rotating
clockwise until secure.
To Next Page
Loading...
