Honeywell Apex - Page 67

67
MAN0604_Issue 09_02-2013 Apex
2110M8030
4. OPERATION
Fault relay conguration example
Requirement: Normally De-energised, Non-Latching with the contact Normally Closed.
Implementation: Use the Congure Relays menu option to set the Fault relay operation
requirement. Place the jumper on the J1 linktosetthecontactoperationasfollows:
This circuit diagram shows this.
Normally
Closed
Normally
Open
Fault Common
Fault
J1
Fault
Alarm 1
Alarm 2
SK6
6
5
4
3
2
1
Fault
Relay
(Relay in
de-energised
state)
Other relays
similar
J2 J3
J1