Honeywell C300 - CEEC300 Function Block; Main Tab

R500
April 2017
Series 8 C300 Controller User's Guide
Honeywell
119
5. C300 Configuration Form Reference
5.3. CEEC300 Function Block
5.3 CEEC300 Function Block
The CEEC300 function block is created when a new C300 Controller block is created
and configured in the Project tree in Control Builder. The following sections identify and
describe all user-visible parameters associated on the CEEC300 configuration form. For
more details about these parameters refer the Control Builder Parameter Reference.
Main Tab
The Main tab is used for the configuration of the CEEC300 block. Refer to the To
configure a CEEC300 Function Block for the steps to configure a CEEC300 block. This
tab also displays important state information and supports generation of commands to the
CEEC300 through parameters. The following table summarizes the parameter data you
can monitor and/or configure on the Main tab of the configuration form for the selected
CEEC300 block.
Plain Text
Parameter Name
User
Configurable
Notes
Main
Tag Name
Tag Name
Project Only
System assigned or
user configured unique
name. Consisting of up
to 16 characters and at
least one character
must be a letter (A-Z).
Item Name
Item Name
Project Only
A non-unique name by
which an entity is known
within the
context of the enterprise
model.
Base Execution
Period
BASEPERIOD
Yes
Indicates the base
execution period for the
CEE block.
Command/State
Control Execution
Environment(CEE)
Command
CEECOMMAND
Yes
Indicates the command
to change the
CEESTATE parameter.