Series 8 C300 Controller User's Guide
Honeywell
4. C300 Controller Configuration
This chapter describes the information about creating and configuring the various
function blocks using Control Builder. Also included are procedures to create Control
Modules in which control strategies are built. The control modules then can be assigned
to a CEE block.
The following table provides the sections covered in this chapter. Click the topic to view
it.
Define and add assets in your enterprise model
C300 Controller Device Index
Create C300 Controller and CEE function blocks
Configure a Secondary C300 Controller block
Convert a non-redundant C300 Controller to a redundant controller
Convert a redundant C300 Controller to a non-redundant controller
Configure IOLINK function blocks
Import/export C300 Controller configuration
Res et Device Index and IP address of a controller
Assign Control Modules and IOMs to a CEEC300 block
Assign I/O Modules to C300 IOLINK blocks
Add an I/O Channel to a Control Module
To Next Page
Loading...
