Honeywell C300 - Server History Tab

5. C300 Configuration Form Reference
5.1. C300 Controller Block
112
Series 8 C300 Controller User's Guide
Honeywell
R500
April 2017
Plain Text
Parameter Name
User
Configurable
Notes
Uncorrectable
Internal RAM Sweep
Error
RAMSWEEPERR
No
Uncorrectable single-bit
errors in Main RAM.
Corrected Internal
RAM Sweep Error
RAMSCRUBERRS
No
Corrected single-bit errors
in Main RAM.
Uncorrectable User
RAM Sweep Error
BACKUPRAMSWEEPE
RR
No
Uncorrectable single-bit
errors in Application RAM.
Corrected User RAM
Sweep Error
BACKUPRAMSCRUBE
RRS
No
Corrected single-bit errors
in Application RAM.
IOLink (1) Soft Fail
Error
IOL1SOFTFAIL
No
Soft fail condition detected
on IOLink 1 interface.
Refer to the IOLink 1
block Main Tab.
IOLink (2) Soft Fail
Error
IOL2SOFTFAIL
No
Soft fail condition detected
on IOLink 2 interface.
Refer to the IOLink 2
block Main Tab.
Debug Flag Enabled
DEBUGFLAGSET
No
Warning: Engineering
internal debug flag is set.
Minimum HW
Revision
MINHWREVSF
No
Partner Not Visible
On FTE
PARTNERNOTVISFTE
No
Indicates redundant
module partner is not
visible on FTE.
Server History tab
The Server History tab is common to all configuration forms for tagged blocks in Control
Builder. The following table summarizes the parameter data you can monitor and
configure on this tab of the configuration form for the selected C300 block.
ATTENTION
The configuration settings you make for Server Load Options on the System
Preferences dialog box determines if the data entered on the Server History
tab is loaded to the Experion LX Server. Refer to the Control Building User’s