Honeywell C300 - Page 75

4. C300 Controller Configuration
4.10. Create a Control Module
R500
April 2017
Series 8 C300 Controller User's Guide
Honeywell
71
Step
Action
Note: If the Control Module's chart is NOT open in the control drawing area,
right-click on the new Control Module in the Project Tree to display the
selection options and click Module Properties… to open the Control Module
parameter configuration form for input.
3
Enter a new Control Module name in the Name field along with a description
in the Description field.
4
Using the F1 key to access context-sensitive Help, fill in the remaining fields
as required.