5. C300 Configuration Form Reference
5.1. C300 Controller Block
Series 8 C300 Controller User's Guide
Honeywell
configure on the Redundancy tab of the configuration form for the selected C300 block.
Refer to the Redundancy parameters for further descriptions of these parameters.
Note that the Redundancy tab is exposed only when the Controller is configured as
redundant. The Module is redundant check box (MODISREDUN parameter) is checked
on the Main tab of the C300 block.
Triggers a synchronizing/
synchronized/standby
redundant controller pair
to abort synchronization.
Triggers an
unsynchronized secondary
controller to transition into
the primary role in the
absence of a partner
controller.
Triggers an
unsynchronized redundant
controller pair to attempt
initial-synchronization.
Triggers a redundancy
role change where the
original primary controller
reboots into the secondary
role and the Synchronized
or Standby secondary
controller assumes the
primary role to continue
control operations.
Auto Synchronization
State
Shows current auto
synchronization state. If
enabled, not synchronized
controllers will attempt to
synchronize automatically
when conditions permit.
To Next Page
Loading...
Need help?
General
