GX-Series Control Panel Installation and Setup Guide
6-119
7. Press the esc key. Outputs is displayed,
8. Press the A key. Status is displayed. Press the ent key to select this option,
9. Unset Disabled is displayed,
10. Press the A key. Entry/ Exit Disabled is displayed,
11. Press the A key. Part Set Disabled is displayed,
12. Press the # key. Part Set Alarm is displayed,
13. Press the A key. Full Set Disabled is displayed,
14. Press the # key. Full Set Alarm is displayed,
15. Press the esc key. Status is displayed,
16. Press the A key. Setting is displayed. Press the ent key to select this option,
17. Begin Set Disabled is displayed,
18. Press the A key. Sets System Disabled is displayed,
19. Press the # key. Sets System Enabled is displayed,
20. Press the esc key. Setting is displayed,
21. Press the A key. Log is displayed. Press the ent key to select this option,
22. Log Disabled is displayed,
23. Press the # key. Log Entry/Exit is displayed,
24. Press the # key. Log 24 H
ours is displayed,
25. Press the esc key three times to return to the 64 = ASSEMBLE ZONES display.
To Next Page
Loading...
