Honeywell GX-Series User Manual

GX-Series Control Panel Installation and Setup Guide
F-1
Appendix F: Parts List Index
Product Name Part No Comments
Replacement PCB’s
GX-48 PCB A321-C-A1
GX-520 PCB A323-C-A1 With expander
Accessories
Serial Peripheral interface Key A227
Keypad
GX Mk7 Keypad CP037-01 With volume control
TouchCenter CP041-A1
Remote Modules
RIO (PCB) A158-B
RIO (boxed) C072-A1
Ethernet Module E080-2
Access Control
Door Control module C080
SPI Key Programmer C087
Software Packages:
Remote Servicing Suite
Licensing K it
Upgrade
License K it (Dongle)
Upgrade (Dongle)
UL NOTES:
1. Supply line transient protection complying with the Standard for Transient Voltage Surge
Suppressors, UL 1449, with a maximum marked rating of 330 V.
2. Signal line transient protection complying with the Standard for Protectors for Data Communications
and Fire Alarm Circuits, UL 497B, with a maximum marked rating of 50 V.
3. Communication circuits and network components connected to the telecommunications network shall
be protected by secondary protectors for communication circuits. These protectors shall comply with
the Standard for Secondary Protectors For Communications Circuits, UL 497A. These protectors
shall be used only in the protected side of the telecommunications network.
4. Equipment to be installed in a temperature controlled environment. A temperature controlled
environment is defined as one that can be maintained between 13 - 35°C (55 - 95°F) by the HVAC
system. Twenty-four hours of standby power shall be provided for the HVAC system. The standby
power system for the HVAC system may be supplied by an engine driven generator alone. A standby
battery is not required to be used.
5. The installed UPS shall comply with the Standard for Uninterruptable Power Supply Equipment, UL
1778, or the Standard for Fire Protective Signaling Devices, UL 1481.
6. To perform maintenance and repair service, a means for disconnecting the input to the UPS while
maintaining continuity of power to the automation system shall be provided. Measured with no load
on zone input.
7. The central station receiving equipment is limited to receiving signals from a maximum of 1000
accounts.

Honeywell GX-Series Specifications

General

Brand	Honeywell
Model	GX-Series
Category	Control Panel
Language	English