GX-Series Control Panel Installation and Setup Guide
6-83
Option 56 – Communications
The Communications option is used to program the GX-Series Communication peripherals. This option
has 7 sub menus, one for each of the communication peripherals. Each of these has its own set of sub menus
as detailed in the following pages.
1 = Int Telecoms (Comm 1)
This section supports programming of the on-board Telecom module, for alarm signaling and remote
servicing over PSTN.
2 = NOT USED
3 = NOT USED
4 = Ethernet (Comm 4)
This section supports programming of the Ethernet module for alarm signaling and remote servicing over an
Ethernet LAN/WAN using both TCP/IP and UDP/IP protocols.
5 = NOT USED
6 = Int RS232 (Comm 6)
This section supports programming of the on-board RS232 port.
7 = NOT USED
To Next Page
Loading...
