Using iLO 4 configuration utilityUsing iLO 4 configuration utility
ProcedureProcedure
1. Access the System Utilities menu .
2. Navigate through the menu options System ConfigurationSystem Configuration > iLO 4 Configuration UtilityiLO 4 Configuration Utility > Network OptionsNetwork Options. The Network Options
screen displays.
3. Change DHCP EnableDHCP Enable to OFF .
4. Configure the IP AddressIP Address , Subnet MaskSubnet Mask , and Gateway AddressGateway Address as required. The following image is an example of a completed
Network OptionsNetwork Options screen.
5. Once completed, press ESCESC to back out of the menus. Save the settings when prompted.
6. After saving all settings, iLO prompts for a reset in order for the new settings to be used. Reset the system.
To Next Page
Loading...
