HP HPE Edgeline EL1000

To Next Page

To Previous Page

Viewing or updating the DHCP address using the serial console cableViewing or updating the DHCP address using the serial console cable

ProcedureProcedure

1. Access the System Utilities menu .

2. For iLO 4, navigate through the menu options System ConfigurationSystem Configuration > iLO 4 Configuration UtilityiLO 4 Configuration Utility > NetworkNetwork > DNS/DHCPDNS/DHCP, and press

EnterEnter. The Network AutoconfigurationNetwork Autoconfiguration screen displays.

For iLO 5, navigate through the menu options System ConfigurationSystem Configuration > iLO 5 Configuration UtilityiLO 5 Configuration Utility > NetworkNetwork > DNS/DHCPDNS/DHCP, and press

EnterEnter. The Network AutoconfigurationNetwork Autoconfiguration screen displays.

3. View or update the DHCP settings.

4. To save any changes, press the F10F10 key.

5. After saving all settings, iLO prompts for a reset in order for any new settings to be used. Reset the system.

Viewing or updating the DHCP address using the serial console cable 88