To replace the component, see “Installing a hot-pluggable SAS hard drive” (page 28).
Power supply blank
To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
Figure 20 Removing the blank
To replace the component, reverse the removal procedure.
Hot-swap power supply
WARNING! To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
106 Removal and replacement procedures
To Next Page
Loading...
