200
<CEa1> system-view
[CEa1] multicast routing
[CEa1-mrib] quit
# Assign an IP address to GigabitEthernet 2/1/1, and enable PIM-SM on the interface.
[CEa1] interface gigabitethernet 2/1/1
[CEa1-GigabitEthernet2/1/1] ip address 10.110.7.1 24
[CEa1-GigabitEthernet2/1/1] pim sm
[CEa1-GigabitEthernet2/1/1] quit
# Assign an IP address to GigabitEthernet 2/1/2, and enable PIM-SM on the interface.
[CEa1] interface gigabitethernet 2/1/2
[CEa1-GigabitEthernet2/1/2] ip address 10.110.2.2 24
[CEa1-GigabitEthernet2/1/2] pim sm
[CEa1-GigabitEthernet2/1/2] quit
# Configure RIP.
[CEa1] rip 2
[CEa1-rip-2] network 10.0.0.0
6. Configure CE b1:
# Enable IP multicast routing.
<CEb1> system-view
[CEb1] multicast routing
[CEb1-mrib] quit
# Assign an IP address to GigabitEthernet 2/1/1, and enable PIM-SM on the interface.
[CEb1] interface gigabitethernet 2/1/1
[CEb1-GigabitEthernet2/1/1] ip address 10.110.8.1 24
[CEb1-GigabitEthernet2/1/1] pim sm
[CEb1-GigabitEthernet2/1/1] quit
# Assign an IP address to GigabitEthernet 2/1/2, and enable PIM-SM on the interface.
[CEb1] interface gigabitethernet 2/1/2
[CEb1-GigabitEthernet2/1/2] ip address 10.110.3.2 24
[CEb1-GigabitEthernet2/1/2] pim sm
[CEb1-GigabitEthernet2/1/2] quit
# Configure RIP.
[CEb1] rip 3
[CEb1-rip-3] network 10.0.0.0
7. Configure CE a2:
# Enable IP multicast routing.
<CEa2> system-view
[CEa2] multicast routing
[CEa2-mrib] quit
# Assign an IP address to GigabitEthernet 2/1/1, and enable IGMP on the interface.
[CEa2] interface gigabitethernet 2/1/1
[CEa2-GigabitEthernet2/1/1] ip address 10.110.9.1 24
[CEa2-GigabitEthernet2/1/1] igmp enable
[CEa2-GigabitEthernet2/1/1] quit
# Assign an IP address to GigabitEthernet 2/1/2, and enable PIM-SM on the interface.
[CEa2] interface gigabitethernet 2/1/2
To Next Page
Loading...
