7. Pull out the paper.
CAUTION: Be careful not to touch the pinchwheels: they are sharp and can cut your ngers.
8. Make sure there are no loose pieces of paper left.
9. Close the output module.
10. Lower the tray.
11. Wait until the printer is ready for paper.
12. The printer resumes the job and automatically reprints any lost pages. However, you should check that
all pages of the job have been printed.
Paper jam in the no-fold tray
IMPORTANT: This operation must be performed by a service engineer or by someone else with appropriate
training.
1. Open the top cover of the tray.
2. Cut the paper between the printer and the folder, if necessary.
3. Remove the paper.
44 Chapter 2 Paper handling ENWW
To Next Page
Loading...