Turn the printer on and o
If you wish to turn the printer on or o or reset the printer, the normal and recommended method is to use
the Power key on the front panel.
However, if you plan to store the printer for a long period or the Power key does not seem to work, you are
recommended to turn it o using the power switch at the rear.
To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about 3 minutes to initialize and check and prepare the print
bar. Preparing the print bar takes about 75 seconds. However, if the printer has been o for 2 weeks or more,
preparing the print bar could take up to 7 minutes, plus 13 minutes if it needs a printhead recovery.
See also Sleep mode on page 10.
Internal prints
The internal prints give various kinds of information about your printer. They can be requested from the front
panel.
Before requesting any internal print, check that the printer and the paper are ready for printing.
●
The loaded paper should be at least A3 landscape—420 mm (16.53 in) wide—otherwise the print may
be clipped.
●
The front panel should be displaying the Ready message.
To print any internal print, press , then scroll down to Internal prints and press it, then select the
internal print you want. The following internal prints are available.
●
Demo prints show some of the capabilities of the printer
ENWW Turn the printer on and o 13