Cleaning container
The cleaning container is a replaceable part that collects waste ink in liquid form, with a capacity of about 2
liters.
The cleaning container is designed to keep the printer’s waste ink from damaging the printer and dirtying its
surroundings.
In order to achieve these objectives, you must ensure that it is correctly installed and maintained, changing it
when prompted by the front panel.
TIP: You are recommended to wear gloves when replacing the cleaning container.
Always replace the cleaning container with the printer switched on, otherwise the counters may not work
properly.
If the printer continues operating while the container is incorrectly installed or connected, HP will not be
responsible for any resulting damage or cleaning expenses.
You can check the cleaning container status in the front panel.
Cleaning container status
●
Ready
●
Missing: The cleaning container is not detected.
●
Almost full: This is estimated by the printer.
●
Full: The printer has stopped printing. It will continue after the cleaning container has been replaced.
Cleaning container part number
The HP 841 cleaning container has the part number F9J47A.
Replace the cleaning container
ENWW Cleaning container 59
To Next Page
Loading...