HP PageWide XL 4000

Submitting a job to the folder
NOTE: While the folder is installed, it is the printer’s default output device. If you submit a job without
specifying a folding style, the default style is applied. You can press to change the folder settings or
default folding styles.
NOTE: If you want to stack jobs in the folder without folding them, select Not folded as the folding style.
NOTE: In most cases the title block (legend) should be on the leading edge of the document entering the
folder. The title block position has to be set in the printing software you are using (by rotation if necessary).
To use the folder, select it as follows when sending the job to print:
●
Front panel: Go to job properties, delivery output, and select Folder.
When printing from a USB ash drive, or copying, you will be able to select the folder as the output
destination and select the folding style.
●
Printer driver: Go to printer properties, delivery output, and select Folder.
The rst time you use the folder, you must specify the folding styles that you expect to use. To do that,
go to the front panel and press , then Output destination > Printing from driver; from there you
can assign one folding style to each
predene.
ENWW Folder 91