HP StorageWorks 12000 User Manual

2. Slide the drive into the bay until it clicks.
Power Supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever (1), and then pull the power supply from the node.
To replace the component:
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to
the power supply until the power supply is installed.
1. Remove the protective cover from the connector pins on the power supply.
HP StorageWorks 12000 Gateway Virtual Library System User Guide 201

HP StorageWorks 12000 Specifications

General

Product Name	HP StorageWorks 12000
Management Software	HP StorageWorks Command View
Form Factor	Rack-mountable
Type	Gateway
Category	Gateway
Connectivity	iSCSI