HP StorageWorks 12000 User Manual

3. Present the LUNs:
CAUTION:
Present only the disks that you wish to use with the VLS Gateway because existing data will
be destroyed during storage pool configuration.
a. In Command View EVA, in the Storage tab navigation tree, select the EVA for the VLS
Gateway storage system, Virtual Disks, the disk name that you want to present, then ACTIVE
under that disk.
b. Select the Presentation tab.
c. Ensure that Write Protect is set to No.
d. Ensure that the Preferred path/mode is set to either Path A-Failover only or Path B-Failover
only (Figure 10).
NOTE:
Set the Preferred path/mode for half of the disks to Path A-Failover only, and to
Path B-Failover only for the other half of the disks. This balances the data traffic across
both A and B controllers. For more information on data traffic balancing, see “Array
Dual Pathing” on page 141.
Figure 10 Vdisk Active Member Properties window
.
e. Click on Present, then select the VLS Gateway host (just created) on the Present Vdisk screen
on the status pane.
f. Click on Present Vdisk.
g. The Operation Succeeded message displays on the status pane. Click OK.
h. Repeat these steps for each disk to present to the VLS.
HP StorageWorks 12000 Gateway Virtual Library System User Guide 39

HP StorageWorks 12000 Specifications

General

Product Name	HP StorageWorks 12000
Management Software	HP StorageWorks Command View
Form Factor	Rack-mountable
Type	Gateway
Category	Gateway
Connectivity	iSCSI