7. Power on the new switch.
USB LAN Adapter Replacement
To replace the USB LAN adapter:
1. If you are replacing the USB LAN adapter (as opposed to simply re-inserting the existing one),
power off the node and switch to which the USB LAN adapter is attached. See Powering Off the
System.
2. Disconnect the USB LAN adapter by unplugging the USB cable from the node and unplugging
the Ethernet cable from the adapter.
3. Connect the new USB LAN adapter by connecting the USB cable to the node port from which
the previous cable was removed, and plugging the Ethernet cable into the USB LAN adapter.
4. If you powered off the system, power on the system. See Powering on the VLS12000 System.
Component Replacement208
To Next Page
Loading...
Need help?
General