This section describes how to remove and install a filler tray.
Removing a filler tray
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Lift the drive release latch at the green touch point,
and then gently slide the filler tray out of the
chassis
2
as shown in the following figure.
TIP: Excess power cables can be stored in the filler tray. Remove the cables before removing
the tray from the chassis.
Figure 5-20 Removing a filler tray
90 Chapter 5 Replacing components ENWW
To Next Page
Loading...
