HPE 5900 series

130
<Sysname> display ip load-sharing path ingress-port Ten-GigabitEthernet 1/0/3
packet-format ipv4oe destination-ip 10.110.0.2 source-ip 10.100.0.2 ip-pro 153 dest-port
2000 src-port 2000 vpn-instance vpn10
Load-sharing algorithm: 0
Load-sharing options: ingress-port | dest-ip | src-ip | ip-pro | dest-port | src-port
Load-sharing parameters:
Missing configured are set to 0.
ingress-port: Ten-GigabitEthernet1/0/3
packet-format: IPv4oE
dest-ip: 10.110.0.2
src-ip: 10.100.0.2
ip-pro: 153
dest-port: 2000
src-port: 2000
vpn-instance: VPN10
Path selected: 20.0.0.2(interface Ten-GigabitEthernet1/0/3)
Table 29 Command output
Field
Description
Load-sharing algorithm Load sharing algorithm ID.
Load-sharing options
Load sharing options specified by the
ip load-sharing mode
command.
Load-sharing parameters
Load sharing parameters that you specify for the
display ip
load-sharing path
command.
Missing configured are set to 0. Values of the unconfigured parameters are set to 0.
ingress-port Ingress port of the packet.
packet-format Packet encapsulation format.
dest-ip Destination IP address of the packet.
src-ip Source IP address of the packet.
ip-pro IP protocol number.
dest-port Destination port number.
src-port Source port number.
vpn-instance Name of the MPLS L3VPN instance.
Path selected
Selected path information, including the IPv4 or IPv6 address of the next
hop and the egress port.
ip load-sharing local-first enable
Use ip load-sharing local-first enable to enable local-first load sharing.
Use undo ip load-sharing local-first enable to disable local-first load sharing.
Syntax
ip load-sharing local-first enable
undo ip load-sharing local-first enable
Default
Local-first load sharing is enabled.