HPE 5900 series

78
Views
System view
Predefined user roles
network-admin
Usage guidelines
DHCP client detects IP address conflict through ARP packets. An attacker can act as the IP address
owner to send an ARP reply, which makes the client unable to use the IP address assigned by the
server. As a best practice, disable duplicate address detection when ARP attacks exist on the
network.
Examples
# Disable the duplicate address.
<Sysname> system-view
[Sysname] undo dhcp client dad enable
dhcp client dscp
Use dhcp client dscp to set the DSCP value for DHCP packets sent by the DHCP client.
Use undo dhcp client dscp to restore the default.
Syntax
dhcp client dscp dscp-value
undo dhcp client dscp
Default
The DSCP value in DHCP packets is 56.
Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Sets the DSCP value for DHCP packets, in the range of 0 to 63.
Usage guidelines
The DSCP value of a packet specifies the priority level of the packet and affects the transmission
priority of the packet. A bigger DSCP value represents a higher priority.
Examples
# Set the DSCP value for DHCP packets sent by the DHCP client to 30.
<Sysname> system-view
[Sysname] dhcp client dscp 30
dhcp client identifier
Use dhcp client identifier to configure a DHCP client ID for an interface.
Use undo dhcp client identifier to restore the default.