HPE 5900 series

30
DHCP server commands
The term "interface" in this section collectively refers to Layer 3 interfaces, including VLAN interfaces
and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the
port link-mode route command (see Layer 2—LAN Switching Configuration Guide).
address range
Use address range to configure an IP address range in a DHCP address pool for dynamic
allocation.
Use undo address range to remove the IP address range in the DHCP address pool.
Syntax
address range start-ip-address end-ip-address
undo address range
Default
No IP address range is configured.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
start-ip-address: Specifies the start IP address.
end-ip-address: Specifies the end IP address.
Usage guidelines
If no IP address range is specified, all IP addresses in the subnet specified by the network command
in address pool view are assignable. If an IP address range is specified, only the IP addresses in the
IP address range are assignable.
After you use the address range command, you cannot use the network secondary command to
specify a secondary subnet in the address pool.
If you use the command multiple times, the most recent configuration takes effect.
The address range specified by the address range command must be within the subnet specified by
the network command, and the addresses out of the address range cannot be assigned.
Examples
# Specify an address range of 192.168.8.1 through 192.168.8.150 in address pool 1.
<Sysname> system-view
[Sysname] dhcp server ip-pool 1
[Sysname-dhcp-pool-1] address range 192.168.8.1 192.168.8.150
Related commands
class
dhcp class
display dhcp server pool
network