HPE 5900 series

200
Default
No IPv6 global unicast address is configured for an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies an IPv6 address.
prefix-length: Specifies a prefix length in the range of 1 to 128.
Usage guidelines
Like public IPv4 addresses, IPv6 global unicast addresses are assigned to ISPs. This type of
address allows for prefix aggregation to reduce the number of global routing entries.
If you do not specify any parameters, the undo ipv6 address command removes all IPv6 addresses
of an interface.
Examples
# Set the IPv6 global unicast address of VLAN-interface 100 to 2001::1 with prefix length 64.
Method 1:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1/64
Method 2:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1 64
ipv6 address anycast
Use ipv6 address anycast to configure an IPv6 anycast address for an interface.
Use undo ipv6 address anycast to remove the IPv6 anycast address of the interface.
Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } anycast
undo ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } anycast
Default
No IPv6 anycast address is configured for an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies an IPv6 anycast address.
prefix-length: Specifies a prefix length in the range of 1 to 128.