EasyManua.ls Logo

HPE 5900 series

HPE 5900 series
319 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
199
Field
Description
INP_REUSEPORTReuses the port number.
INP_ANONPORT—Port number not specified.
INP_PROTOCOL_PACKETIdentifies a protocol packet.
INP_RCVVLANIDReceives the VLAN ID of the packet. Only UDP
and RawIP support this flag.
IN6P_IPV6_V6ONLYOnly supports IPv6 protocol stack.
IN6P_PKTINFOReceives the source IPv6 address and input
interface of the packet.
IN6P_HOPLIMITReceives the hop limit.
IN6P_HOPOPTSReceives the hop-by-hop options extension
header.
IN6P_DSTOPTSReceives the destination options extension
header.
IN6P_RTHDRReceives the routing extension header.
IN6P_RTHDRDSTOPTSReceives the destination options
extension header preceding the routing extension header.
IN6P_TCLASSReceives the traffic class of the packet.
IN6P_AUTOFLOWLABELAttaches a flow label automatically.
IN6P_RFC2292Uses the API specified in RFC 2292.
IN6P_MTUDiscovers differences in the MTU size of every link
along a given data path. TCP does not support this flag.
INP_RCVMACADDRReceives the MAC address of the frame.
INP_SYNCPCB—Waits until Internet PCB is synchronized.
N/ANone of the above flags.
Inpcb vflag
IP version flags in the Internet PCB:
INP_IPV4IPv4 protocol.
INP_IPV6IPv6 protocol.
INP_IPV6PROTOCreates an Internet PCB based on IPv6
protocol.
INP_TIMEWAITIn TIMEWAIT state.
INP_ONESBCASTSends broadcast packets.
INP_DROPPED—Protocol dropped flag.
INP_SOCKREFStrong socket reference.
INP_DONTBLOCKDo not block synchronization of the Internet
PCB.
N/ANone of the above flags.
Hop limit(minimum hop limit)
Hop limit in the Internet PCB. The minimum number of hops is in the
parentheses.
Send VRF Sent instances.
Receive VRF Received instances.
ipv6 address
Use ipv6 address to configure an IPv6 global unicast address for an interface.
Use undo ipv6 address to remove the IPv6 global unicast address of the interface.
Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]

Table of Contents

Other manuals for HPE 5900 series

Related product manuals