HPE 5900 series

25
Examples
# Display brief IP configuration information for VLAN interfaces.
<Sysname> display ip interface vlan-interface brief
*down: administratively down
(s): spoofing (l): loopback
Interface Physical Protocol IP Address Description
Vlan10 down down 6.6.6.1 Vlan-inte...
Vlan2 down down 7.7.7.1 Vlan-inte...
Table 4 Command output
Field
Description
*down: administratively
down
The interface is administratively shut down with the
shutdown
command.
(s) : spoofing
Spoofing attribute of the interface. It indicates that an interface might have no link
present even when its link layer protocol is up or the link is established only on
demand.
Interface Interface name.
Physical
Physical state of the interface:
• *down—The interface is administratively shut down with the shutdown
command.
• down—The interface is administratively up but its physical state is down
(possibly because of poor connection or line failure).
• up—Both the administrative and physical states of the interface are up.
Protocol
Link layer protocol state of the interface:
• down—The protocol state of the interface is down (typically when no IP
address is configured for the interface).
• up—The protocol state of the interface is up.
• up(s)—The protocol state of the interface is up (spoofing).
IP Address
IP address of the interface. If no IP address is configured,
unassigned
is
displayed.
Description
Interface description information.
A maximum of 12 characters can be displayed. If there are more than 12
characters, only the first 9 characters are displayed.
Related commands
display ip interface
ip address
ip address
Use ip address to assign an IP address to the interface.
Use undo ip address to remove the IP address from the interface.
Syntax
ip address ip-address { mask-length | mask } [ irf-member member-id | sub ]
undo ip address [ ip-address { mask-length | mask } [ irf-member member-id | sub ] ]
Default
No IP address is assigned to an interface.