HPE 5900 series

279
Related commands
ipv6 dhcp snooping enable
ipv6 dhcp snooping option interface-id string
ipv6 dhcp snooping option interface-id string
Use ipv6 dhcp snooping option interface-id string to specify the content as the interface ID for
Option 18.
Use undo ipv6 dhcp snooping option interface-id string to restore the default.
Syntax
ipv6 dhcp snooping option interface-id [ vlan vlan-id ] string interface-id
undo ipv6 dhcp snooping option interface-id [ vlan vlan-id ]
Default
The DHCPv6 snooping device uses its DUID as the content for Option 18.
Views
Layer 2 Ethernet interface/Layer 2 aggregate interface view
S-channel interface/S-channel aggregate interface view
VSI interface/VSI aggregate interface view
Predefined user roles
network-admin
Parameters
vlan vlan-id: Specifies the VLAN where the DHCPv6 clients resides.
interface-id: Specifies a string of 1 to 128 characters as the interface ID.
Examples
# Specify company001 as the interface ID.
<Sysname> system-view
[Sysname] ipv6 dhcp snooping enable
[Sysname] interface Ten-GigabitEthernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] ipv6 dhcp snooping option interface-id enable
[Sysname-Ten-GigabitEthernet1/0/1] ipv6 dhcp snooping option interface-id string
company001
Related commands
ipv6 dhcp snooping enable
ipv6 dhcp snooping option interface-id enable
ipv6 dhcp snooping option remote-id enable
Use ipv6 dhcp snooping option remote-id enable to enable support for the remote-ID option (also
called Option 37).
Use undo ipv6 dhcp snooping option remote-id enable to restore the default.
Syntax
ipv6 dhcp snooping option remote-id enable