HPE 5900 series

136
Views
System view
Predefined user roles
network-admin
Parameters
aging-time: Specifies the aging time for fast forwarding entries, in the range of 10 to 300 seconds.
Examples
# Set the aging time of fast forwarding entries to 20 seconds.
<Sysname> system-view
[Sysname] ip fast-forwarding aging-time 20
Related commands
display ip fast-forwarding aging-time
ip fast-forwarding load-sharing
Use ip fast-forwarding load-sharing to enable fast-forwarding load sharing.
Use undo ip fast-forwarding load-sharing to disable fast-forwarding load sharing.
Syntax
ip fast-forwarding load-sharing
undo ip fast-forwarding load-sharing
Default
Fast-forwarding load sharing is enabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
Fast-forwarding load sharing enables the device to identify a data flow by using the five-tuple (source
IP, source port, destination IP, destination port, and protocol). The device then forwards packets of
the same flow to implement load sharing.
If fast-forwarding load sharing is disabled, the device identifies a data flow by the five-tuple and the
input interface. No load sharing is implemented.
Examples
# Enable fast-forwarding load sharing.
<Sysname> system-Views
[Sysname] ip fast-forwarding load-sharing
reset ip fast-forwarding cache
Use reset ip fast-forwarding cache to clear fast forwarding table information.
Syntax
reset ip fast-forwarding cache [ slot slot-number ]