HPE 5900 series

176
checksum error 0 bad length 0
path MTU changed 0 destination unreachable 0
too big 0 parameter problem 0
echo request 0 echo reply 0
neighbor solicit 0 neighbor advertisement 0
router solicit 0 router advertisement 0
redirect 0 router renumbering 0
output: parameter problem 0 echo request 0
echo reply 0 unreachable no route 0
unreachable admin 0 unreachable beyond scope 0
unreachable address 0 unreachable no port 0
too big 0 time exceed transit 0
time exceed reassembly 0 redirect 0
ratelimited 0 other errors 0
display ipv6 interface
Use display ipv6 interface to display IPv6 interface information.
Syntax
display ipv6 interface [ interface-type [ interface-number ] ] [ brief ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type: Interface type.
interface-number: Interface number.
brief: Displays brief information.
Usage guidelines
If you specify the brief keyword, this command displays brief information including physical status,
link-layer protocols, and IPv6 address.
If you do not specify the brief keyword, this command displays detailed information including IPv6
configuration and operating information, and IPv6 packet statistics.
If you do not specify an interface, this command displays IPv6 information about all interfaces.
If you specify only the interface-type argument, this command displays IPv6 information about the
interfaces of the specified type.
If you specify both the interface-type and the interface-number arguments, this command displays
IPv6 information about the specified interface.
Examples
# Display IPv6 information about VLAN-interface 2.
<Sysname> display ipv6 interface vlan-interface 2
Vlan-interface2 current state: UP
Line protocol current state: UP