HPE 5900 series

258
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do
not specify an interface, this command displays DHCPv6 server addresses on all interfaces enabled
with DHCPv6 relay agent.
Examples
# Display DHCPv6 server addresses on all interfaces enabled with DHCPv6 relay agent.
<Sysname> display ipv6 dhcp relay server-address
Interface: Vlan-interface2
Server address Outgoing Interface
2::3
3::4 Vlan-interface4
Interface: Vlan-interface3
Server address Outgoing Interface
2::3
3::4 Vlan-interface4
# Display DHCPv6 server addresses on VLAN-interface 2.
<Sysname> display ipv6 dhcp relay server-address interface vlan-interface 2
Interface: Vlan-interface2
Server address Outgoing Interface
2::3
3::4 Vlan-interface4
Table 62 Command output
Field
Description
Server address DHCPv6 server address specified on the DHCP relay agent.
Outgoing Interface
Output interface of DHCPv6 packets. If no output interface is specified,
the device searches the routing table for the output interface.
Related commands
ipv6 dhcp relay server-address
ipv6 dhcp select
display ipv6 dhcp relay statistics
Use display ipv6 dhcp relay statistics to display DHCPv6 packet statistics on the DHCPv6 relay
agent.
Syntax
display ipv6 dhcp relay statistics [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator