HPE 5900 series

35
[Sysname] dhcp server always-broadcast
dhcp server apply ip-pool
Use dhcp server apply ip-pool to apply an address pool on an interface.
Use undo dhcp server apply ip-pool to remove the configuration.
Syntax
dhcp server apply ip-pool pool-name
undo dhcp server apply ip-pool
Default
No address pool is applied on an interface
Views
Interface view
Predefined user roles
network-admin
Parameters
pool-name: Specifies the name of a DHCP address pool, a case-insensitive string of 1 to 63
characters.
Usage guidelines
Upon receiving a DHCP request from the interface, the DHCP server searches for a static binding for
the client from all address pools. If no static binding is found, the server assigns configuration
parameters from the address pool applied on the interface to the client. If the address pool has no
assignable IP address or does not exist, the DHCP client cannot obtain an IP address.
If you use the command multiple times, the most recent configuration takes effect.
Examples
# Apply DHCP address pool 0 on VLAN-interface 2.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] dhcp server apply ip-pool 0
Related commands
dhcp server ip-pool
dhcp server bootp ignore
Use dhcp server bootp ignore to configure the DHCP server to ignore BOOTP requests.
Use undo dhcp server bootp ignore to restore the default.
Syntax
dhcp server bootp ignore
undo dhcp server bootp ignore
Default
The DHCP server does not ignore BOOTP requests.