HPE 5900 series

65
undo dhcp relay client-information refresh
Default
The refresh interval is automatically calculated based on the number of relay entries.
Views
System view
Predefined user roles
network-admin
Parameters
auto: Automatically calculates the refresh interval. The more the entries, the shorter the refresh
interval. The shortest interval must not be less than 500 ms.
interval interval: Specifies the refresh interval in the range of 1 to 120 seconds.
Usage guidelines
If you use this command multiple times, the most recent configuration takes effect.
Examples
# Set the refresh interval to 100 seconds.
<Sysname> system-view
[Sysname] dhcp relay client-information refresh interval 100
Related commands
dhcp relay client-information record
dhcp relay client-information refresh enable
dhcp relay client-information refresh enable
Use dhcp relay client-information refresh enable to enable the DHCP relay agent to periodically
refresh dynamic relay entries.
Use undo dhcp relay client-information refresh enable to disable the DHCP relay agent to
periodically refresh dynamic relay entries.
Syntax
dhcp relay client-information refresh enable
undo dhcp relay client-information refresh enable
Default
The DHCP relay agent periodically refreshes relay entries.
Views
System view
Predefined user roles
network-admin
Usage guidelines
A DHCP client unicasts a DHCP-RELEASE message to the DHCP server to release its IP address.
The DHCP relay agent conveys the message to the DHCP server and does not remove the
IP-to-MAC entry of the client.
With this feature, the DHCP relay agent uses the IP address of a client and the MAC address of the
DHCP relay interface to periodically send a DHCP-REQUEST message to the DHCP server.