HPE 5900 series

198
Inpcb vflag: INP_IPV6
Hop limit: 255 (minimum hop limit: 0)
Send VRF: 0xffff
Receive VRF: 0xffff
Table 53 Command output
Field
Description
Total UDP socket number Total number of IPv6 UDP sockets.
Slot ID of the IRF member device.
Creator Task name of the socket. The progress number is in the square brackets.
State Socket state.
Options Socket options.
Error Error code.
Receiving
buffer(cc/hiwat/lowat/state)
Displays receive buffer information in the following order:
• cc—Used space.
• hiwat—Maximum space.
• lowat—Minimum space.
• state—Buffer state:
 CANTSENDMORE—Unable to send data to the peer.
 CANTRCVMORE—Unable to receive data from the peer.
 RCVATMARK—Receiving tag.
 N/A—None of the above states.
Sending
buffer(cc/hiwat/lowat/state)
Displays send buffer information in the following order:
• cc—Used space.
• hiwat—Maximum space.
• lowat—Minimum space.
• state—Buffer state:
 CANTSENDMORE—Unable to send data to the peer.
 CANTRCVMORE—Unable to receive data from the peer.
 RCVATMARK—Receiving tag.
 N/A—None of the above states.
Type
Socket type:
• 1—SOCK_STREAM. This socket uses TCP to provide reliable
transmission of byte streams.
• 2—SOCK_DGRAM. This socket uses UDP to provide datagram
transmission.
• 3—SOCK_RAW. This socket allows an application to change the
next upper-layer protocol header.
• N/A—None of the above types.
Protocol Number of the protocol using the socket. 17 represents UDP.
Connection info
Connection information, including source IPv6 address and port number,
and destination IPv6 address and port number.
Inpcb flags
Flags in the Internet PCB:
• INP_RECVOPTS—Receives IPv6 options.
• INP_RECVRETOPTS—Receives replied IPv6 options.
• INP_RECVDSTADDR—Receives destination IPv6 address.
• INP_HDRINCL—Provides the entire IPv6 header.
• INP_REUSEADDR—Reuses the IPv6 address.