292
Line protocol state
Link layer protocol state of the tunnel interface. The value is
determined by the parameter negotiation on the link layer.
• UP—The protocol state of the interface is up.
• UP (spoofing)—The link protocol state of the interface is up,
but the link is temporarily set up on demand or does not exist.
This attribute is available for null interfaces and loopback
interfaces.
• DOWN—The protocol state of the interface is down.
Description Description of the tunnel interface.
Bandwidth Intended bandwidth for the tunnel interface.
Maximum Transmit Unit MTU of the tunnel interface.
Internet Address
IP address of the tunnel interface.
If no IP address is assigned to the interface, this field displays
Internet protocol processing: disabled
, and the tunnel interface
cannot process packets.
Primary
indicates it is the primary IP address of the interface.
Tunnel source
Source address of the tunnel. If a source interface is specified for the
tunnel interface, this field also displays the source interface in
parentheses.
destination Destination address of the tunnel.
Tunnel encapsulation-limit is
disabled
Tunnel nested encapsulation is not supported.
Tunnel TTL TTL of tunneled packets.
Tunnel protocol/transport
Tunnel mode and transport protocol:
• GRE/IP—GRE/IPv4 tunnel mode.
• GRE/IPv6—GRE/IPv6 tunnel mode.
• IP/IP—IPv4 over IPv4 tunnel mode.
• IPv6—IPv6 tunnel mode.
• IPv6/IP—IPv6 over IPv4 manual tunnel mode.
• IPv6/IP 6to4—IPv6 over IPv4 6to4 tunnel mode.
• IPv6/IP ISATAP—IPv6 over IPv4 ISATAP tunnel mode.
Last clearing of counters Last time of clearing counters.
Last 300 seconds input: 0 bytes/sec,
0 packets/sec
Average input rate in the last 300 seconds.
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average output rate in the last 300 seconds.
# Display brief information about the interface Tunnel 1.
<Sysname> display interface tunnel 1 brief
Brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Tun1 UP UP 1.1.1.1 aaaaaaaaaaaaaaaaaaaaaaaaaaa
# Display brief information about interface Tunnel 1, including the complete interface description.
<Sysname> display interface tunnel 1 brief description
Brief information of interface(s) under route mode: