HPE 5920 series

111
ip host
Use ip host to create a host name-to-IPv4 address mapping.
Use undo ip host to remove a mapping.
Syntax
ip host host-name ip-address [ vpn-instance vpn-instance-name ]
undo ip host host-name ip-address [ vpn-instance vpn-instance-name ]
Default
No mappings are created.
Views
System view
Predefined user roles
network-admin
Parameters
host-name: Specifies a host name, a case-insensitive string of 1 to 253 characters. It can include
letters, digits, hyphens (-), underscores (_), and dots (.).
ip-address: Specifies the IPv4 address of the host.
vpn-instance vpn-instance-name: Specifies the name of an MPLS L3VPN instance, a
case-sensitive string of 1 to 31 characters. To specify a host name-to-IP address mapping on the
public network, do not specify this option.
Usage guidelines
You can configure the following:
•
Host name-to-IPv4 address mappings for the public network and up to 1024 VPNs.
•
A maximum of 1024 host name-to-IPv4 address mappings for the public network or each VPN.
On the public network or a VPN, each host name maps only to one IPv4 address. If you use the
command multiple times, the most recent configuration takes effect.
Do not use the ping command parameter ip, -a, -c, -f, -h, -i, -m, -n, -p, -q, -r, -s, -t, -tos, -v, or
-vpn-instance as the host name. For more information about the ping command parameters, see
Network Management and Monitoring Command Reference.
Examples
# Map IPv4 address 10.110.0.1 to host name aaa on the public network.
<Sysname> system-view
[Sysname] ip host aaa 10.110.0.1
Related commands
display dns host
ipv6 dns dscp
Use ipv6 dns dscp to set the DSCP value for IPv6 DNS packets sent by an IPv6 DNS client or DNS
proxy.
Use undo ipv6 dns dscp to restore the default.
Syntax
ipv6 dns dscp dscp-value