HPE 5920 series User Manual

114
[Sysname] dns proxy enable
[Sysname] ipv6 dns spoofing 2001::1
Related commands
dns proxy enable
ipv6 host
Use ipv6 host to create a host name-to-IPv6 address mapping.
Use undo ipv6 host to remove a mapping.
Syntax
ipv6 host host-name ipv6-address [ vpn-instance vpn-instance-name ]
undo ipv6 host host-name ipv6-address [ vpn-instance vpn-instance-name ]
Default
No mappings are created.
Views
System view
Predefined user roles
network-admin
Parameters
host-name: Specifies a host name, a case-insensitive string of 1 to 253 characters. It can include
letters, digits, hyphens (-), underscores (_), and dots (.).
ipv6-address: Specifies the IPv6 address of the host.
vpn-instance vpn-instance-name: Specifies the name of an MPLS L3VPN instance, a
case-sensitive string of 1 to 31 characters. To create a host name-to-IPv6 address mapping on the
public network, do not use this option.
Usage guidelines
You can configure the following:
•
Host name-to-IPv6 address mappings for the public network and up to 1024 VPNs.
•
A maximum of 1024 host name-to-IPv6 address mappings for the public network or each VPN.
For the public network or a VPN, each host name maps only to one IPv6 address. If you use the
command multiple times, the most recent configuration takes effect.
Do not use the ping ipv6 command parameter -a, -c, -i, -m, -q, -s, -t, -tc, -v, or -vpn-instance as the
host name. For more information about the ping ipv6 command parameters, see Network
Management and Monitoring Command Reference.
Examples
# Map IPv6 address 2001::1 to host name aaa on the public network.
<Sysname> system-view
[Sysname] ipv6 host aaa 2001::1
Related commands
ip host

HPE 5920 series Specifications

General

Brand	HPE
Model	5920 series
Category	Switch
Language	English