HPE 5920 series

56
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of a server.
Usage guidelines
Upon startup, the DHCP client obtains an IP address and the specified server IP address. Then it
contacts the specified server, such as a TFTP server, to get other boot information.
If you use the next-server command multiple times, the most recent configuration takes effect.
Examples
# Specify a server's IP address 10.1.1.254 in DHCP address pool 0.
<Sysname> system-view
[Sysname] dhcp server ip-pool 0
[Sysname-dhcp-pool-0] next-server 10.1.1.254
Related commands
display dhcp server pool
option
Use option to customize a DHCP option.
Use undo option to remove a customized DHCP option.
Syntax
option code { ascii ascii-string | hex hex-string | ip-address ip-address&<1-8> }
undo option code
Default
No DHCP option is customized.
Views
DHCP address pool view
Predefined user roles
network-admin
Parameters
code: Specifies the number of the customized option, in the range of 2 to 254, excluding 50 through
54, 56, 58, 59, 61, and 82.
ascii ascii-string: Specifies an ASCII string of 1 to 255 characters as the option content.
hex hex-string: Specifies a hexadecimal string of even numbers from 2 to 256 as the option content.
ip-address ip-address&<1-8>: Specifies the IP addresses as the option content. &<1-8> indicates
that you can specify up to eight IP addresses separated by spaces.
Usage guidelines
The DHCP server fills the customized option with the specified ASCII string, hexadecimal string, or
IP addresses, and sends it in a response to the client.