HPE 5920 series User Manual

289
default settings. If your restoration attempt still fails, follow the error message instructions to resolve
the problem.
Examples
# Restore the default settings of interface tunnel 1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] default
description
Use description to configure a description for a tunnel interface.
Use undo description to restore the default.
Syntax
description text
undo description
Default
The description of a tunnel interface is Tunnelnumber Interface, for example, Tunnel1 Interface.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
text: Specifies a description for the interface, a case-sensitive string of 1 to 255 characters.
Usage guidelines
Configure descriptions for different interfaces for identification and management purposes.
This command configures an interface description and does not have any other function. You can
use the display interface command to display the configured interface description.
Examples
# Configure the description for the interface Tunnel 1 as tunnel1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] description tunnel1
Related commands
display interface tunnel
destination
Use destination to specify the destination address for a tunnel interface.
Use undo destination to remove the configured tunnel destination address.
Syntax
destination { ip-address | ipv6-address }
undo destination

HPE 5920 series Specifications

General

Brand	HPE
Model	5920 series
Category	Switch
Language	English